Integrity Air Conditioning and Heating Services provides heater and air conditioning repair, installation, and services in Dallas, WA and surrounding areas. Check out what some of our customers are saying about Integrity Air Conditioning and Heating Services
Local Reviews
for Dallas, TX
Powered by Nearby NowAlways exceeds expectations
Bernard - Dallas, TX
Integrity is prompt and always gives me a report I can understand on the status of our systems. Their communication is excellent. I get reminder calls, but never feel pressured.
Great Service
George - Dallas, TX
Spring cleaning of HCAC. Changed all filters and cleaned units and coils. Nice job
Christopher M.
High pressure switch tripped reset washed coils checked pressures and split as well as electrical unit is cooling
Christopher M.
Checked water cooled unit temps were off checked cooling tower filter line temps at unit seem to be off looker for a water filter need to return ASAP and check further
Christopher M.
Found float switch tripped so I blew drain also recommended they replace thermostat did repairs unit is cooling properly
Christopher M.
Found bad cap Replaced cap unit is now cooling properly
Christopher M.
Water leak drain pan full vacuumed blew drain replaced ceiling tile vacuumed unit is clear and cooling
Christopher M.
Fixed drain line that was leaking
Christopher M.
3 system tune up added turbo hard start kits one of the zone dampers is acting up may need to come back and replace units are cooling
Christopher M.
Found bad cap replaced with turbo 200 checked amp draw unit is cooling properly
Christopher M.
Checked unit pressures were high washed out coil checked subcooling it was great unit is cooling
Christopher M.
Preformed cooling tune up customer also purchased maintenance agreements
Christopher M.
Preformed tune up unit needs new cap and contractor needs to be replace pressures look great unit is cooling washed coil
Christopher M.
Fixed vent pipe
Christopher M.
Preformed tune up blew drain added float switch
Christopher M.
Preformed tune up replace blower cap checked pressure washed condenser unit is cooling properly
Christopher M.
Unit low on Freon checked for leak recharged unit unit is cooling will get customer quote on new coil
Christopher M.
Condenser was making noise shaft on condenser fan motor was loose removed and replaced motor unit is not making noise anymore
Christopher M.
Shaft on condenser fan motor was loose causing noise removed and replaced motor unit is not making the noise anymore
Christopher M.
Filter dryer leaking Freon removed and replaced unit is coolin
Christopher M.
Preformed tune up unit was low on r22 leak in evaporator coil need to replace
Christopher M.
Preformed cooling tune up checked pressure and all components unit was draining home is cooling
Christopher M.
Tune up
Christopher M.
Change plug on compressor add 410a unit is now cooling
Christopher M.
3 system tune up blew drain line and stapled some insulation material that was beginning to fall checked all components units are cooling
Christopher M.
Unit not cooling found bad thermostat replaced with new Honeywell WiFi stat unit is now cooling
Christopher M.
Unit was leaking in ceiling found rusted out drain pan went and picked up new one then replace also blew drain line unit is cooling
Christopher M.
Returned and replaced disconnect unit is cooling properly
Christopher M.
Two system tune up unit are cooling properly informed customer about IAQ products and suggested out door disconnect be changed
Christopher M.
Preformed tune up added r22 unit is cooling properly recommend new unit due to age and leak in system Justin will return in the morning to offer options and quote for replacement
Christopher M.
Installed 3 Honeywell T4 thermostats checked and operations.
Christopher M.
Quarterly maintenance changed filters checked electrical components checked pressures replaced arma flex changed capacitor and a two pole contact and washed condenser coils units are cooling properly
Christopher M.
2 system tune up unit are cooling properly
Christopher M.
Preformed 2 system tune up blew drains added new turbo 200
Christopher M.
Maintenance, changed filters checked pressures and temp checked capacitors and belts washed condenser coils removed blower wheel and cleaned on package unit all units are cooling properly
Christopher M.
Installed new 2 ton split system inspected Job confirmed that unit was heating and cooling
Christopher M.
Unit was not cooling checked pressures unit had no Freon checked for leak at condenser it was good checked for leak at evap coil with leak detector evap coil had leak need to get a quote over for replacement
Christopher M.
Maintenance found on splits system low on 410a washed coils checked pressures checked capacitors looked over all electrical components unit are now cooling properly
Christopher M.
3 system tune up
Christopher M.
Washed coils
Christopher M.
Replaced two duct runs
Justin D.
Changing filters and performing quarterly maintenance for a commercial customer.
Christopher M.
Heating tune up on 2 units one electric heat the other unit was infinity system heat pump both units were heating properly
Justin D.
Chris fixing a electric heat strip on a cold February day. Customer is now nice and cozy!
Christopher M.
Did maintenance at clutch bar changed filters checked heating operation found bad heat exchanger
Justin D.
Installing a new Amana Electric Air Handler. Got a customer approved for financing and unit installed all in a matter of hours.
Justin D.
Our crew hard at work Installing two new complete Amana HVAC Systems.
